FAAC Gate Opener Repair in Plano and Frisco
FAAC is best known for hydraulic swing gate operators, both arm-mounted units and underground models buried beneath the gate. Hydraulic units fail differently from screw or gear drives, so we check fluid, seals and valves along with the electronics.
Open 24 hours, 7 days a week

Common trouble with FAAC hydraulic gate operators
Oil on the ram or the ground
A hydraulic operator moves the gate with pressurized fluid. A wet ram, a drip under the unit or an oily ring around an underground box means a seal is leaking.
Gate drifts or will not hold
Low fluid or worn internal valves can let a closed gate creep open in the wind or let an open gate wander.
Sluggish on cold mornings
Hydraulic fluid thickens when it is cold, so a gate that crawls on a winter morning and runs normally by afternoon may need its fluid or settings checked.
Water around an underground unit
Underground swing operators sit in a box below the drive. If the drain clogs during a heavy rain, water collects around the motor.
What to have ready when you call
Look for the label on the operator, usually on the side of the housing or inside the cover, and read us the brand, model and serial number. It also helps to know:
- Whether the operator is mounted on the gate or buried beneath it
- Any oil you can see and where it is
- Whether the gate moves by hand after using the release key
- How the problem changes with the weather or time of day
See also: gate opener repair, safety sensor and loop repair and emergency gate repair.
FAAC gate questions
There is oil under my FAAC operator. Can I keep using the gate?
A leak means the operator is losing pressure, so the gate may not move, hold or stop the way it should. Use it as little as you can and call us to check the seals and fluid.
Do you work on FAAC gates in Plano and Frisco?
Yes. We repair FAAC equipment in Plano, Frisco, Richardson, Murphy, Wylie, Parker and Sachse, around the clock. Call (469) 393-4388 for pricing on your gate, and ask about current discounts.
Are you a FAAC dealer?
No. Collin Gate Repair is an independent repair company with no affiliation to FAAC. We work on the equipment already on your gate.
FAAC is a trademark of its owner. Collin Gate Repair is an independent repair company, not affiliated with or endorsed by any manufacturer.
FAAC gate down? Call us.
Open 24 hours, 7 days a week. Call for pricing. Ask about current discounts when you call.